Scheme showing the technical scope of NEA ICDE project activities, NEA
Common-cause failure (CCF) events can significantly affect the availability of safety systems of nuclear power plants. In recog...
Published date:
30 November 2022
Scheme of the PKL facility, Framatome GmbH.
The SESAR Thermal-hydraulics (SETH) Project began in 2001 and consisted of thermal-hydraulic experiments in support of accident management, which were ca...
Published date:
2 October 2023
Scheme of the THAI+ facility, Becker Technologies.
The experimental investigations carried out in the frame of the THAI (2007-2009), THAI-2 (2011-2014) and THAI-3 (2016-2019) projects contributed s...
Published date:
2 October 2023
In a core melt accident, if the molten core is not retained in-vessel despite severe accident mitigation actions, the core debris will relocate to the reactor cavity region and interact with the stru...
Published date:
2 October 2023
Image: Microscopic examination of U-bearing particles collected at Fukushima-Daiichi, JAEA
TCOFF Phases
First Phase (2017-2020)
The Thermodynamic Characterisation of Fuel Debris and Fission Products ...
Published date:
6 October 2023
General view of the EREC test facility BC V-213, source: EREC
There are several VVER-440/213* type nuclear power plants operating in the Czech Republic, Hungary, Slovak Republic, Russia and Ukraine...
Published date:
6 October 2023
PKL facility. Photo: FRAMATOME, Germany
The Primärkreislauf-Versuchsanlage (Primary Coolant Loop Test Facility [PKL]) is a facility owned and operated by Framatome GmbH (formerly AREVA NP) in Erlange...
Published date:
6 October 2023
Scheme of the PSB-VVER facility, EREC
The NEA PSB-VVER project provided unique and useful experimental data for code validation using the PSB-VVER test facility. The PSB-VVER facility is a large-scal...
Published date:
6 October 2023
View of the RASPLAV-3 Facility.
The Material Scaling (MASCA) Project was a follow-up of the RASPLAV Project and investigated in-vessel phenomena during a severe accident with core melt. Specifica...
Published date:
6 October 2023
Published date:
7 November 2023
Control room, PAKS NPP.
Software-based systems are used and retrofitted in operating nuclear power plants worldwide. The failure modes of both hardware and software in these systems are to some ext...
Published date:
7 November 2023
Post-test view inside OLHF-4 vessel showing penetrations and resolidified weld material at the vessel bottom.
During a severe accident, the lower head of a reactor pressure vessel (RPV) can be subj...
Published date:
27 October 2023
EPICUR facility, IRSN.
STEM phases
First phase (2011-2015)
The STEM Project was initiated with a first phase in 20...
Published date:
27 October 2023
Experts from 16 countries met on 13-15 September for the 24th annual Working Group on Fuel Safety GFS meeting in Paris.
Published date:
27 October 2023
Photo: RBHT Test Facility. US NRC.
Modelling reactor core behaviour under accident conditions with delayed re-introduction of cooling water (commonly referred to as reflood) is a challenge for safety...
Published date:
27 October 2023
A Task Group on Advanced Reactor Experimental Facilities (TAREF) had been set up to provide an overview of facilities suitable for carrying out safety research on gas-cooled and sodium fast reactors....
Published date:
28 April 2020
This task group was set up to carry out a pilot project using the methodology propsed in the final SMAP report published in 2007. In this pilot project, the SMAP methodology was applied to the Zion n...
Published date:
27 April 2020
This working group's objective was to advance the current understanding and to address safety issues related to fuel safety margins, in particular to systematically assess the technical basis for cur...
Published date:
29 April 2020
The Senior Expert Group on Safety Research Opportunities Post-Fukushima (SAREF) was established at the June 2013 CSNI meeting to identify research activities to address safety research knowledge gaps...
Published date:
4 February 2021
The Senior Expert Group on Safety Research / Support Facilities for Existing and Advanced Reactors 2 (SESAR/SFEAR2) is responsible for reviewing and updating the previous SESAR assessments of researc...
Published date:
22 April 2020
PKL facility. Photo: FRAMATOME, Germany
The Experimental Thermal Hydraulics for Analysis, Research and Innovations in Nuclear Safety (ETHARINUS) project serves the objectives of investigating phenome...
Published date:
9 December 2022
HYMERES phases
First phase (2013-2016)
The main objective of the first phase of the Hydro...
Published date:
6 April 2020
Studsvik’s pool facility for storage and inspection of SMILE materials, left: 29 tonnes transportation flask, three pools each about 8 meters deep; and right: pool-in-pool for cutting and inspections...
Published date:
11 October 2022
Left: Test facility for qualification of melt spreading tests. Photo: Argonne National Laboratory (ANL).
Right: Example of corium melt pouring for a melt spreading preparatory test. Photo: Argonne Nat...
Published date:
6 April 2023
Cabri Reactor (Commissariat à l’énergie atomique et aux énergies alternatives)
The Cabri International Project (CIP) began in March 2000 to study the behaviour of nuclear fuel rods and cladding durin...
Published date:
26 April 2023
Image: QUENCH facility at KIT. Court. KIT.
The purpose of the QUENCH-ATF project is to investigate the chemical, mechanical and thermal-hydraulics behaviour of ATF claddings in Design Basis Accident...
Published date:
17 May 2023
The Committee on the Safety of Nuclear Installations (CSNI) is responsible for NEA programmes and activities that support maintaining and advancing the scientific and technical knowledge base of the ...
Published date:
10 October 2023
The OECD NEA RASPLAV Project provided experiments with prototypical material and data on the behavior of molten core material (corium) in the reactor pressure vessel lower head during a severe accide...
Published date:
6 October 2023
Electrical cable fire test, IRSN.
The NEA PRISME project addressed in a series of 3 phases from 2006 till 2022 fire risk research. Operating experience shows that fire is one of the highest risks i...
Published date:
4 October 2023
NEA/CSNI/R(2014)13/REV1
This document is an extension of the NEA/SEN/SIN/AMA(2006)2 report produced by the Writing Group 3 on the extension of CFD to two-phase flow safety problems, which was formed following the recommen...
Published date:
1 November 2014
PAKS Nuclear Power Plant, Hungary.
During a fuel crud removal operation on the Paks-2 unit on 10 April 2003, several fuel assemblies were severely damaged. The assemblies were being cleaned in a sp...
Published date:
2 October 2023
Image at melt distribution and its contour at MBC (KAERI).
The Committee on the Safety of Nuclear Installations (CSNI) Working Group on Analysis and Management of Accidents (WGAMA) initiated a co...
Published date:
2 October 2023
Multi-compartment THAI+ test facility, Becker Technologies GmbH.
In the wake of the OECD/NEA THAI project, conducted in three phases from 2007 until 2019, a new project, THAI Experiments on Mitigat...
Published date:
2 October 2023
View looking down onto the LOFT reactor
The Loss-of-fluid Test (LOFT) Research Programme was originally set up by the US Nuclear Regulatory Commission. Part of the programme was later broadened int...
Published date:
2 October 2023
With the growing importance of SMRs, following the proposal of the CSNI Bureau, the CSNI has decided to create an Expert Group on SMRs (EGSMR), at its 69th meeting held on 2-3 June 2021.
Published date:
7 April 2023
NEA Working Group on Analysis and Management of Accidents (WGAMA) initiated this activity focusing on computational fluid dynamics (CFD) in nuclear reactor safety (NRS).
Published date:
1 September 2023
The NEA Working Group on the Analysis and Management of Accidents convened for its annual meeting to discuss ongoing work related to accident strategy and management.
Published date:
14 September 2023
NEA/CSNI/R(2022)2
The eighth instalment of the workshop on computational fluid dynamics for nuclear reactor safety (CFD4NRS-8) was organised by the Nuclear Energy Agency (NEA) Committee on the Safety of Nuclear Instal...
Published date:
28 August 2023
Experts attended NEA event in France.
Published date:
14 September 2023
The main mission of the Working Group on External Events (WGEV) is to improve the understanding and treatment of external hazards that would support the continued safety performance of nuclear instal...
Published date:
10 February 2022
11 -
13 September 2023
IRSN, Fontenay-aux-Roses, France
Published date:
4 September 2023
The scope of the proposed project is therefore to perform practical exercises of demonstration of the SAPIUM approach.
Published date:
1 September 2023
Irradiation Vessel with Coupons, CNL
The NEA Behaviour of Iodine Project (BIP) was created to provide separate effects and modelling studies of iodine behaviour in a nuclear reactor containment bui...
Published date:
31 August 2023
PANDA vessel assembly (construction phase, 1993), PSI.
The PANDA project is a follow-up of the HYMERES-2 project, and its general objective is to advance the knowledge on the containment of thermal...
Published date:
31 August 2023
Scheme of the DIVA Facility, IRSN
The Fire Risk Assessment through Innovative Research Project is a follow-up of the PRISME project series which addresses new fire scenarios and new topics of inter...
Published date:
31 August 2023
NEA/CSNI/R(2021)8
The objective of the NEA THAI-3 project was to address open questions concerning the behaviour of hydrogen, iodine and aerosols under severe accident conditions in the containment of water cooled rea...
Published date:
28 August 2023
NEA/CSNI/R(2020)7
The cold leg mixing computational fluid dynamics (CFD) – uncertainty quantification (CLM-UQ) benchmark is the fifth benchmark concerning CFD applications to nuclear reactor safety to be organised in ...
Published date:
3 November 2022
Published date:
30 September 2022
14 -
16 November 2023
Office for Nuclear Regulation, Merton Road, Bootle, Merseyside L20 7HS, United Kingdom
The workshop on the Approaches to design, implementation and operation of electrical systems for beyond design basis equipment and management of geomagnetically induced currents in electrical systems...
Published date:
22 June 2023
Supporting the use of computational fluid dynamics for nuclear reactor safety
Published date:
27 June 2023